Windows 10 reached EOS (end of support) on October 14, 2025. If you are on Windows 10, see this article.

Mozilla サポートの検索

サポート詐欺に注意してください。 私たちはあなたに通話やショートメッセージの送信、個人情報の共有を求めることはありません。疑わしい行為を見つけたら「迷惑行為を報告」からご報告ください。

詳しく学ぶ
このスレッドはアーカイブに保管されました。 必要であれば新たに質問してください。
アーカイブに保管済み

How can I see HTML DOM structure via console in Firefox?

shcherban.daniil

How can I see HTML DOM structure via console in Firefox?

In Chrome when I type "document" in the console, I see clearly the HTML DOM structure. When I do this in FireFox I get a bunch of extra info and it's even hard to figure out the the HTML DOM structure. My question is: Where to find or how to display the HTML DOM in FireFox the way it's displayed in Chrome? DOM tool is enabled but shows completely different information (I tried DOM tab in tools it is not the same). Didn't find any solutions for this.

How can I see HTML DOM structure via console in Firefox? In Chrome when I type "document" in the console, I see clearly the HTML DOM structure. When I do this in FireFox I get a bunch of extra info and it's even hard to figure out the the HTML DOM structure. My question is: Where to find or how to display the HTML DOM in FireFox the way it's displayed in Chrome? DOM tool is enabled but shows completely different information (I tried DOM tab in tools it is not the same). Didn't find any solutions for this.
添付されたスクリーンショット

すべての返信 (5)

Firefox links you over to the Inspector (similar to Chrome's Elements panel) for that. See attached screenshot.

But this is not the same, inspector is fine but console doesn't show clear structure of HTML element, however Chrome has clear HTML structure straight away. Is it any way to set it up as on Chrome?

I am not aware of a setting for that. You could ask on the Dev Tools forum:

https://discourse.mozilla.org/c/devtools/213

By the way, what is the benefit of displaying an HTML tree in the Console vs. the Inspector?

This way it is showing HTML tree straight away without going to inspector, like Chrome does

But on the other hand, you need to run a script in the console when instead you could use the filter bar on the Inspector. But I understand it's hard to change a workflow that has become efficient for us.