Windows 10 will reach EOS (end of support) on October 14, 2025. For more information, see this article.

Avatar for Username

Prohledat stránky podpory

Vyhněte se podvodům. Za účelem poskytnutí podpory vás nikdy nežádáme, abyste zavolali nebo poslali SMS na nějaké telefonní číslo nebo abyste sdělili své osobní údaje. Jakékoliv podezřelé chování nám prosím nahlaste pomocí odkazu „Nahlásit zneužití“.

Zjistit více

Toto vlákno bylo archivováno. Pokud potřebujete pomoci, založte prosím nový dotaz.

the procedure entry point NSSUTIL_EscapeSize could not be located in the dynamic link library nssutil3.dll

  • 2 odpovědi
  • 8 má tento problém
  • 24 zobrazení
  • Poslední odpověď od peterC1

peterC1
peterC1
more options

Windows XP with Firefox 18.0.1 wont open when upgraded to latest version. Error messages were (1) the procedure entry point PR_SetCurrentThreadName could not be located in the dynamic link library ndpr4.dll (2) the procedure entry point NSSUTIL_EscapeSize could not be located in the dynamic link library nssutil3.dll (3) could not load XPCOM

Ran malware & virus software then removed Firefox via Control panel, then residual folder from Programme files folder and from C:\Documents&Settings\Administrator\Local Folders\ApplicationData\Mozilla. Sourced & installed ndpr4.dl and nssutil3.dll - fresh reinstall firefox several times - this got rid of error message 1 but not 2 or 3 and still can't open Firefox. Any solutions?

Windows XP with Firefox 18.0.1 wont open when upgraded to latest version. Error messages were (1) the procedure entry point PR_SetCurrentThreadName could not be located in the dynamic link library ndpr4.dll (2) the procedure entry point NSSUTIL_EscapeSize could not be located in the dynamic link library nssutil3.dll (3) could not load XPCOM Ran malware & virus software then removed Firefox via Control panel, then residual folder from Programme files folder and from C:\Documents&Settings\Administrator\Local Folders\ApplicationData\Mozilla. Sourced & installed ndpr4.dl and nssutil3.dll - fresh reinstall firefox several times - this got rid of error message 1 but not 2 or 3 and still can't open Firefox. Any solutions?

Zvolené řešení

I have this problem and I am using Zone Alarm Extreme Security with Force Field enabled. I found that by clearing the Virtual Cache in Zone Alarm that this problem went away and was able to run firefox again.

Here is a post I found that addresses the issue sort of. http://kb.mozillazine.org/Browser_will_not_start_up#Firefox_does_not_start_after_updating_with_ZoneAlarm_ForceField_enabled

Přečíst dotaz v kontextu 👍 2

Všechny odpovědi (2)

crengieer
crengieer
more options

Zvolené řešení

I have this problem and I am using Zone Alarm Extreme Security with Force Field enabled. I found that by clearing the Virtual Cache in Zone Alarm that this problem went away and was able to run firefox again.

Here is a post I found that addresses the issue sort of. http://kb.mozillazine.org/Browser_will_not_start_up#Firefox_does_not_start_after_updating_with_ZoneAlarm_ForceField_enabled

peterC1
peterC1 Autor dotazu
more options

Thank you cregieer I turned of virtual virtualization in Zone Alarm and problem solved. Firefox starts up flawlessly.