Windows 10 reached EOS (end of support) on October 14, 2025. If you are on Windows 10, see this article.

Prohledat stránky podpory

Vyhněte se podvodům. Za účelem poskytnutí podpory vás nikdy nežádáme, abyste zavolali nebo poslali SMS na nějaké telefonní číslo nebo abyste sdělili své osobní údaje. Jakékoliv podezřelé chování nám prosím nahlaste pomocí odkazu „Nahlásit zneužití“.

Zjistit více
Vyřešeno Archivováno

Message Composition: Can only enter one To: addressee per message

roger77

Very weird - I've been using Thunderbird for a couple of decades and have never seen this before . . .

When composing a message I can only enter one To: addressee. It is only displaying one line to enter a To: addressee. I cannot figure out a way to add a second or third To: addressee.

The same is true for cc: and bcc: there is a line to enter one, but that is it.

I'd greatly appreciate any help anyone could provide.

Very weird - I've been using Thunderbird for a couple of decades and have never seen this before . . . When composing a message I can only enter one To: addressee. It is only displaying one line to enter a To: addressee. I cannot figure out a way to add a second or third To: addressee. The same is true for cc: and bcc: there is a line to enter one, but that is it. I'd greatly appreciate any help anyone could provide.

Všechny odpovědi (3)

Zvolené řešení

Thanks for the quick response Wayne, however I was unable to find a solution in the articles you referenced.

In those articles they all state that after entering an addressee and hitting <enter> or <tab> will allow you to enter subsequent To: addressees.

When I enter an addressee and hit <enter> or <tab> the only thing that happens is the cursor indexes to the Subject: line. A new addressee box does not appear.

Okay, I get it now . . . thanks!