搜尋 Mozilla 技術支援網站

防止技術支援詐騙。我們絕對不會要求您撥打電話或發送簡訊,或是提供個人資訊。請用「回報濫用」功能回報可疑的行為。

Learn More

after updating to 38.0.1 fm 15.0.1 gets incoming email messages but then hangs the entire syst CAUSE: HWA

  • 4 回覆
  • 10 有這個問題
  • 4 次檢視
  • 最近回覆由 Platrix

more options

I was on auto update release channel but had not been asked to update since 2012. Now 38.0.1. Freezes (need power down to restart) my W7 Pro after receiving last incoming email. Disabling add-on's did not help. I removed calendar. Am able to send fine. Any thoughts? Thanks in advance (Note I will probably have to turn off and restart after receiving your reply so if there is any way to chat without email would be good). Thanks again.

I was on auto update release channel but had not been asked to update since 2012. Now 38.0.1. Freezes (need power down to restart) my W7 Pro after receiving last incoming email. Disabling add-on's did not help. I removed calendar. Am able to send fine. Any thoughts? Thanks in advance (Note I will probably have to turn off and restart after receiving your reply so if there is any way to chat without email would be good). Thanks again.

由 Wayne Mery 於 修改

被選擇的解決方法

If it works in Windows safe mode, then the problem is some other software that is loaded during Windows boot. For examle antivirus software

從原來的回覆中察看解決方案 👍 3

所有回覆 (4)

more options

So Calendar is causing your problem?

more options

Thanks very much for responding...

I don't think calendar was the problem as it continues after I removed it.. Still hanging with all addons removed. Works ok in W7 pro safemode.

Same thing in 3 diff user accounts. Probably something in W7 that was triggered by my update to Thunderbird to 38.0.1 from a version dated 2012.

more options

選擇的解決方法

If it works in Windows safe mode, then the problem is some other software that is loaded during Windows boot. For examle antivirus software

more options

I had the same problem, but found out the turning off hardware acceleration solves the problem (Thunderbird 38.1.0 on Windows 7 (64), Intel G41)

Uncheck "Use hardware acceleration when available" in Tools - Options - Advanced: General or set true for "gfx.direct2d.disabled" in configuration editor