Avatar for Username

Prohledat stránky podpory

Vyhněte se podvodům. Za účelem poskytnutí podpory vás nikdy nežádáme, abyste zavolali nebo poslali SMS na nějaké telefonní číslo nebo abyste sdělili své osobní údaje. Jakékoliv podezřelé chování nám prosím nahlaste pomocí odkazu „Nahlásit zneužití“.

Learn More

Toto vlákno bylo archivováno. Pokud potřebujete pomoci, založte prosím nový dotaz.

Flame won't boot after update (1.4)

  • 2 odpovědi
  • 1 má tento problém
  • 3 zobrazení
  • Poslední odpověď od sailfish009

amfg
amfg
more options

Hello, I was running nightly FFOS 1.4 on my Flame for last month. Today, after update and reboot, phone boots into recovery mode. It looks like fastboot (I can see only ThunderSoft(r) logo) but I can't see phone listed with fastboot command. It does, however, respond through adb. Commands like adb shell are not limited. What should I do now? I rather ask for help now, since I have already broken my zte -.- This time I didn't do anything strange to it so.. Will be glad for any response. Thank you

Hello, I was running nightly FFOS 1.4 on my Flame for last month. Today, after update and reboot, phone boots into recovery mode. It looks like fastboot (I can see only ThunderSoft(r) logo) but I can't see phone listed with fastboot command. It does, however, respond through adb. Commands like adb shell are not limited. What should I do now? I rather ask for help now, since I have already broken my zte -.- This time I didn't do anything strange to it so.. Will be glad for any response. Thank you

Všechny odpovědi (2)

amfg
amfg Autor dotazu
more options

Since I am terribly impatient, I have flashed it to 2.0 with v180. Seems to work now.

sailfish009
sailfish009
more options

fastboot mode: power button + volume-down button for 10 ~ 20 seconds

recovery mode: power button + volume-up button for 10 ~ 20 seconds

firmware update is much easier in linux rather than windows.

flame phone should be in unplugged and power-off state.

Upravil uživatel sailfish009 dne